Configuring Qt Creator

TODO: {{#todo: Buggy (11.09.2015-13:55->KY+)(11.13.2015-13:00->MG+)|Brian Serrano|oe 5,bs,ky,mg,md,Buggy}}

NOTE

The target_arch variable referenced below can either be armv5e-emac-linux-gnueabi for ARM targets or i586-emac-linux for x86 targets.

Configure Kits in Qt Creator

WARNING!

This assumes the Qt Creator install is in the user's home directory, but it doesn't say anything about that ahead of time. There's no background information, pre-reqs, etc. This page is unfinished.

1. Open Qt Creator

   developer@ldc:~# /home/developer/qtcreator-3.1.0/bin/qtcreator

2. Click Tools->Options...

3. Select Devices from the left pane

   1. Press the Add... button

   2. Select Generic Linux Device then press Start Wizard

   3. Type in a name, the IP address, user name and password for the device

   4. Click Next >

   5. Click Finish

   6. A connection will be established with the target device

   7. Click Apply

4. Select Build & Run from the left pane

5. Select the Qt Versions tab

   1. Press the Add... button

   2. Navigate to /opt/emac/5.0/sysroots/x86_64-emacsdk-linux/usr/bin/

   3. Select qmake

   4. Press apply

   

   Figure 1: Qt Creator Kit Qmake

   
   

6. Select the Compilers tab

   1. Press Add->GCC

   2. Type in a name such as OE5 ARM GCC

   3. Click Browse...

   4. Navigate to /opt/emac/5.0/sysroots/x86_64-emacsdk-linux/usr/bin/target_arch/

   5. Select target_arch-gcc

   

   Figure 2: Qt Creator Kit Compiler

   
   

7. Select the Debuggers tab

   1. Press Add

   2. Type in a name such as GDB OE5 ARM

   3. Click Browse...

   4. Navigate to /opt/emac/5.0/sysroots/x86_64-emacsdk-linux/usr/bin/target_arch/

   5. Select target_arch-gdb

   

   Figure 3: Qt Creator Kit Debugger

   
   

8. Select the Kits tab

   1. Press the Add button

   2. Type in a name such as OE 5.0 arm

   3. Change the Device type: to Generic Linux Device

   4. Change the Device: to the one configured in step 3

   5. Type /opt/emac/5.0/sysroots/target_arch into the Sysroot line

   6. Change the Compiler: to the one created in step 6

   7. Change the Debugger: to the one created in step 7

   8. Change the Qt version: to the one created in step 5

   9. Type target_arch-g++ into the Qt mkspec line

   10. Press Apply then Ok

       
       

   

   Figure 4: Qt Creator Kit

   
   

WARNING!

There's no conclusion

WARNING!

There's no, "Where to Go Next."