Difference between revisions of "Example mcp4922 test"
| Line 1: | Line 1: | ||
| − | {{todo|InProgress(11.14.13-15:09->JG+)|Jgreene|project=oe 4,oe 5, | + | {{todo|InProgress(11.14.13-15:09->JG+)|Jgreene|project=oe 4,oe 5,jg,md,InProgress}} |
<big>This procedure provides an overview of how to compile and run the ''mcp4922_test'' C example project. It assumes familiarity with the C programming language and is intended to be used by experienced programmers who are looking to learn the EMAC SDK.</big> | <big>This procedure provides an overview of how to compile and run the ''mcp4922_test'' C example project. It assumes familiarity with the C programming language and is intended to be used by experienced programmers who are looking to learn the EMAC SDK.</big> | ||
Revision as of 09:04, 27 November 2013
This procedure provides an overview of how to compile and run the mcp4922_test C example project. It assumes familiarity with the C programming language and is intended to be used by experienced programmers who are looking to learn the EMAC SDK.
Contents
1. Open the C/C++ editing perspective
2. Open the mcp4922_test project
3. Build, upload and run
What it does
This is an example application for accessing the EMAC interface for the on-board DtoA of the SoM-150ES. This interface uses the EMAC ioex class to provide a GPIO-like interface (see also the egpc project). This application outputs a sine wave on channel 0 and a cosine wave on channel 1.
Usage for mcp4922_test
mcp4922_test
ie: ./mcp4922_test
You'll get the signal on the analog out port. Pin 15 is analog out 0 and pin 16 is analog out 1. GND is 1,2,17,18. Range is 5V. You'll need an oscilloscope and a board schematic.
