Example mcp4922 test
This is a guide to the mcp4922_test C example project included in the EMAC OE SDK.
This is an example application for accessing the EMAC interface for the on-board DtoA of the SoM-150ES. This interface uses the EMAC ioex class to provide a GPIO-like interface (see also the egpc project). This application outputs a sine wave on channel 0 and a cosine wave on channel 1.
The mcp4922_test project builds one executable: mcp4922_test.
Opening, Building and Uploading the Project Files
1. Open the C/C++ editing perspective.
stub
2. Open the project files.
stub
3. Build the project.
stub
4. Upload the executables to the target system.
stub
Usage and Behavior
mcp4922_test outputs a sine wave on channel 0 and a cosine wave on channel 1.
Hardware Requirements
The mcp4922_test C example project requires an EMAC SoM-150ES carrier board.
Usage for mcp4922_test
mcp4922_test
ie: ./mcp4922_test
You'll get the signal on the analog out port. Pin 15 is analog out 0 and pin 16 is analog out 1. GND is 1,2,17,18. Range is 5V. You'll need an oscilloscope and a board schematic.
