Difference between revisions of "CutiPy-Installing MicroPython Firmware"
| Line 1: | Line 1: | ||
| + | |||
| + | ===THIS PAGE IS CURRENTLY UNDER CONSTRUCTION=== | ||
=== Necessary equipment === | === Necessary equipment === | ||
| Line 5: | Line 7: | ||
* 1 Micro-USB cable | * 1 Micro-USB cable | ||
* A pair of needle nose pliers for wire jumper re-positioning | * A pair of needle nose pliers for wire jumper re-positioning | ||
| + | * A personal computer (Windows or Linux) | ||
* EMAC's latest MicroPython firmware release | * EMAC's latest MicroPython firmware release | ||
</cl> | </cl> | ||
| − | |||
| Line 13: | Line 15: | ||
<cl> | <cl> | ||
| − | 1. With the | + | 1. With the USB disconnected and power removed, carefully use a pair of needle nose pliers to shift jumper JB2 upwards from FLS to to RXM. |
| + | * Dowload the USB driver installer, Zadig | ||
| + | * Once installed, open Zadig. | ||
| + | * Connect the the CutiPy to your PC using the micro-USB cable | ||
| + | |||
| + | |||
Revision as of 14:56, 19 August 2019
Contents
THIS PAGE IS CURRENTLY UNDER CONSTRUCTION
Necessary equipment
-
CutiPy
-
1 Micro-USB cable
-
A pair of needle nose pliers for wire jumper re-positioning
-
A personal computer (Windows or Linux)
-
EMAC's latest MicroPython firmware release
Windows Users
<cl> 1. With the USB disconnected and power removed, carefully use a pair of needle nose pliers to shift jumper JB2 upwards from FLS to to RXM.
* Dowload the USB driver installer, Zadig * Once installed, open Zadig. * Connect the the CutiPy to your PC using the micro-USB cable
Linux Users
Follow the EMAC DFU instructions given here
