Cutipy-MicroPython LED Ring Counter demo

Revision as of 16:00, 31 May 2022 by Ebraun (talk | contribs) (Changed the instructions a bit)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Here we will demonstrate the functionality of the LED's on the CutiPy, in addition to timer interrupts and pushbutton functionality.

Required Materials

  1. CutiPy device running MicroPython

  2. A personal computer

  3. script



  1. Connect your CutiPy to your personal computer using a microUSB cable ( Steps Covered Here )

  2. Copy into the CutiPy drive

  3. Reset your CutiPy board to update the file system

  4. Establish a REPL terminal connection ( Steps Covered Here )

  5. In the terminal, import the Ring Counter script using the following command

    >> import


  • Press PB1 once quickly, and the LED's will begin to light in order, going from LED1-LED4 before restarting at LED1 again. Each time the LED's cycle, the REPL connection will display the number of cycles. Press PB1 again to stop the cycle.
  • Hold PB1 for a second, and the same thing happens, except this time the LED's cycle in reverse from LED4-LED1. Press PB1 again to stop the cycle.
  • To exit the demo, press ctrl + d

Additional Information


Bluemix on Micropython

Wifi and MQTT on the RS9113 in Micropython

Cutipy-MicroPython Bluetooth LE demo