STLink

From wiki.emacinc.com
Revision as of 11:37, 29 May 2018 by Dsojka (talk | contribs)
Jump to: navigation, search

The STLink is a debugger and programmer for the STM8 and STM32 microcontroller families.

General Information

Tools Required

Setup

STLink on Windows

1 Start by downloading the STLink utility software here: http://www.st.com/en/development-tools/stsw-link004.html

2 Open the STLink Utility

STLink Utility


3 Click on the 'Binary File' tab in the upper left. A file browser should appear. Navigate to the directory that contains the binary file you plan to use and click 'Open'

STLink File Browse


4 [Optional] Before programming the unit, it is recommended to erase the chip. In the upper left, click 'Target' and then click 'Erase Chip'. You should see the following message if it completes successfully.

STLink Erase Chip


5. In the upper left, click 'Target', then 'Program & Verify'. The following window should appear. Click 'Start'.

STLink Program


6. You should see the following message the programming was successful.

STLink Done


STLink on Linux

Pages with Related Content