STLink

From wiki.emacinc.com
Revision as of 17:23, 29 May 2018 by Dsojka (talk | contribs)
Jump to: navigation, search

The STLink is a debugger and programmer for the STM8 and STM32 microcontroller families.

General Information

Tools Required

  • STLink Programmer
  • USB to MiniUSB cable
  • JTAG cable for interfacing the STLink with the target board

Setup

  • Plug in the USB side of the USB-to-miniUSB cable to your PC and the other side to the STLink programmer.
  • Connect the STLink programmer and your target board with the JTAG cable.
  • Ensure the target board has power.

STLink on Windows

1 Start by downloading the STLink utility software here: http://www.st.com/en/development-tools/stsw-link004.html

2 Open the STLink Utility

STLink Utility


3 Click on the 'Binary File' tab in the upper left. A file browser should appear. Navigate to the directory that contains the binary file you plan to use and click 'Open'

STLink File Browse


4 [Optional] Before programming the unit, it is recommended to erase the chip. In the upper left, click 'Target' and then click 'Erase Chip'. You should see the following message if it completes successfully.

STLink Erase Chip


5. In the upper left, click 'Target', then 'Program & Verify'. The following window should appear. Click 'Start'.

STLink Program


6. You should see the following message the programming was successful.

STLink Done


STLink on Linux

1. Go to https://github.com/texane/stlink, clone the repository, and follow the instructions for installation.

2. Once installed, you can simply open a terminal and issue the following commands:

  • To erase the chip:
    • developer@linux:~# st-flash erase
  • To program board using a hex file:
    • developer@linux:~# st-flash --format ihex write filename.hex
  • To program a board using binary files:
    • developer@linux:~# st-flash write firmware0.bin 0x08000000
    • developer@linux:~# st-flash --reset write firmware1.bin 0x08020000


Pages with Related Content